about Art
Company Profile
Art News
Catalog
Contact Art
Hot Recommended
PCI9103 user's manual
ART2522.rar
ART2153.rar
PCI2325.rar
PCI8504rar
More information
Application of USB Boards ...
Application of PC104 in Wa...
Application of PXI Platfor...
Agents
HomeFAQ
 
Can the data be acquired from all the channels when there is only one signal input channel?
  The A/D board has high input impedance. The value of the input impedance can be 10M-1G Ω. At the same time, there is no resistance between the channel and the ground. So the signal input value can not be zero. To solve the problem, we can connect the vacant channels to the ground or put a 1K-1MΩresistance between the vacant channels and the ground . It certainly will not affect the signal input channel. So if it is not necessary to show the data from the vacant channels, users do not need to care about them.
How to connect the AGND pin and the DGND pin?
  Generally speaking, there is Analog Ground (AGND) pin and Digital Ground (DGND) in a data acquisition board. It will make mistakes unless we connect the AGND pin to the system AGND plane and the DGND pin to the system DGND plane.
How to eliminate the interference that going with the signals in the industrial site?
  Amplify the signal from the sensor and use the shielded wire when transmitting the signal.
Can the data acquisition board sample the voltage signal lower than 1mV?
  The input signal is so low that the data acquisition board can't sample it directly. So the input signal should be amplified, filtered and isolated in order to make it identified by the acquisition board.
What should I do if FIFO is overflowing?
  1)Buy a FIFO with bigger capacity. But this method can't solve the problem radically. The better way is improving the efficiency of the system. 2)Use the DMA mode. It can get a quicker speed than the Interrupt mode. 3)Reduce the sampling frequency. 4)Select a computer which has a better bus performance. 5)Select our company products which have the self-check function. When FIFO is full, the alarm will automatically go off, and sampling process will stop reading the data at the same time.
How the data acquisition board work when doing the continuous sampling?
  When we use the continuous sampling mode, the AD converts the input signals and then put the data into the buffer. If there are several channels, the AD will sample the input signals in turn.
  ->Total25          No.2/5 First  Prev  Next  Last  
 
Contacts Us | Products & Services | Case | Support | About Us
© 2008 Beijing Art Technology Development Co., Ltd. All rights reserved.